This is a touch screen. Touch the "To Main Menu"
option to continue.
Sytem Power - options for switching on or off the AMX
system Source - select the source of the video feed
Screen - raise or lower the display screen Volume
- increase or decrease the speaker volume
AMX System Startup/Shutdown
LCD Projector Use Prompt
Power Up - turns on the system
(The "Shut Down" option does not shutdown the above menu screen)
This appears when you select the source option.
Press yes to turn on the projector.
Projector Warmup Screen
Source Selection Menu
Once the LCD projector is selected, please wait until the projector warms
up. Do not shut down the LCD projector in between. Also, WAIT at least five
minutes before switching the projector on after it is switched off. This
helps extend the projector life.
Appears when the source button is touched.
PC will either be the rack mounted PC or the notebook if connected. This
is usually controlled by the KVM switch which can shift between different
sources.
The AMX wall unit contains 4 components. The VHS cassette player is at the
bottom. The DVD player is located above it. The ports for auxillary
video and audio above it and the rack mounted computer at the top. Appropriate
video/audio source can be selected using the AMX screen menu shown above.
This kind of projector remote has a pull-down cover on some of its controls.
Projector Operation (for projectors not controlled by AMX system)
Turn on by pressing green
button when facing the projector. Hold button down just until something
changes in the projector lens. Release button or projector will take up to
5 minutes to reset.
If there is no picture, try
pressing the RGB button. The picture on the computer is connected to the
projector through RGB#1
If there is a fuzzy picture,
the video button may be been pressed. To correct this, press RGB#1.
To turn off projector, press
green button when facing the projector until you see something in the lens
change. The fan will continue running.
Do not use markers on projector screens, drop
down screens or desktop cameras.
The KVM switches in Engineering school classroom
have already been configured to use Port 1 for main computer, Port 2 for
laptop, Port 3 for Document Camera and Port 4 for auxilary
input. Please do NOT alter this configuration.
This is the the microphone and the wireless transmitter.
The microphone can be attached to the users shirt.
The transmitter has a small toggle switch which controls the mute and unmute operations. Make sure that this switch does not point
to mute while in operation.
